LED TURN SIGNAL, SMOKED
BLACK, 12V/1W
Important notes
LED TURN SIGNAL, SMOKED BLACK, 12V/1W
LED turn signal
Small LED turn signal with smoked glass and black plastic housing.
- 12 V/ 1 W LEDs
- Turn signal dimensions (HxWxD) approx. 23 x 51 x 25 mm
- With approx. 12 mm long, flexible stem
- Approx. 20 mm long M10 x 1.25 thread
- Ready to install incl. cable and connector
- E-approved
- Ø Connection of the indicator arm 14 mm
- Sold individually
Warning: Choking hazard and risk of internal injuries! Small parts can be swallowed. Keep out of reach of children under 3 years of age. Manufacturer: Detlev Louis Motorrad-Vertriebsgesellschaft mbH | Rungedamm 35 | 21035 Hamburg | Germany | Tel. 00 49 (0) 40 – 734 193 60 | service@louis.de | www.louis.de
It all began with a small motorcycle workshop in Hamburg. Since then, Louis has become Europe's largest motorcycle and leisure retailer. And even now, after more than three quarters of a century, we at Louis are no less passionate about life on two wheels.
Modern vehicle accessories of different types now frequently carry an "E" approval mark valid throughout Europe. This "E" mark, which is made up of a combination of letters and numbers, is clearly displayed on the product and shows the application tested, the country in which testing was carried out and, where appropriate, the vehicle type to which approval applies. EC type approval for exhaust systems, for example, are always issued for a specific vehicle type, whereas in the case of lighting, they apply to an entire group of vehicles, e.g. motorcycles.
This certification mark is the sole proof of legality stipulated by law, i.e. no written report or entry in the vehicle documents by TÜV (German Technical Inspection Association) is required. However, when it comes to installing accessories, the relevant guidelines of the Road Traffic Licensing Regulations (StvZO) must always be observed.
At at a roadside check or a TÜV vehicle inspection, the registered keeper is only required to show the "E" mark. It is then up to the official in charge whether to check the mark with the Federal Motor Transport Authority (KBA) in Flensburg (or equivalent type approval authority in other countries), which is able to decode all certification marks.
Original parts on newer vehicles that have been given an "E" mark at the factory may only be replaced with accessories that have likewise undergone E-approval. An E-certified mirror may not, for example, by replaced with a mirror that only has TÜV approval under the German vehicle licensing regulations.
To ensure that your objective and truthful report will be really beneficial to all readers, please observe the following rules.
- Please only rate products that you have personally used for their intended purpose.
- Please give reasons for your positive and negative criticisms. Only then will they benefit other customers and allow us to improve the product if necessary.
- Please don’t copy content that has already been published elsewhere. It’s your personal experience which counts.
- Data protection: Please don’t include your own and other people’s addresses, telephone numbers or URLs or even the names of third parties (people as well as companies) in your review.
- In your product review, please don’t make comparisons with third party product ranges. Regardless of whether you judge these positively or negatively, you, or we as operators of this online shop, would be violating competition law.
Fair play: Please follow these rules so that we don’t have to shorten or delete your rating.
Your product rating has been saved. It will be displayed in a few minutes
Do you really want to cancel your entry?